|
Post by 1985gmc on Jul 26, 2007 21:12:56 GMT -5
Well I purchased a set of bucket seats out of an Acura for my truck I got them for two reasons. 1. They are super comfortable 2. They were only $10.00 for the pair Can't go wrong right. Even if they don't work for some reason I'm just out $10 I never looked at the bottom of the seats till I got them home. This is the problem. It has the bracket on the bottom that you would bolt to the floor, except they are all on a 45 degree angle, so the floor in the Acura was not flat. Should I cut them off and start fresh or make a bracket to mount the seat. I know lots of you guys have buckets take a look and tell me how yours is mounted cause I'm lost at what to do>>thanks in advance>> GOD SPEED
|
|
|
Post by Pontiac1976 on Jul 26, 2007 21:36:04 GMT -5
Well I would make a bracket that will fit on the seat set & bolts to the truck floor . Now be for you do anything test fit the seat Because most car seat's will sit low so you might have to lift it up a little off the floor to see out & drive properly . get a good Idea how much room you got to play with up and down where you want the seat .
|
|