Post by trikepapa on Aug 9, 2009 2:37:13 GMT -5
Trade or Sell or Buy section WANTED : Gauge Cluster Case & Printed Circuit Bo was posted here. Moved here so it would have it's on topic.
Hi, I participated in this thread back in 06 and I believe Pontiac1976 both found what we were looking for. I experienced some medical issues since then and am just getting around to putting the dash in my 76 Chev C20 PU back together. Original cluster had no TACH and the new stock cluster of same year, has a TACH and so, other gauges are rearranged. Shouldn't be a problem since it appears the printed circuit accounts for that. Current status:
1) I have no plug and harness in dash for the TACH and I don't know which of the 3 prongs on back of TACH go to coil, which to switchable hot, and which to ground.
2) Mechanical Oil pressure works fine.
3) Speedometer is fine.
4) Turn signal blinkers and backlights are fine.
5) Amp, Temp and Fuel don't peg, wiggle or register when ignition is turned on.
Can anyone help me trouble shoot the issues> As always, thanks in advance for all help. I hope to make a run at this project this next couple of months and wrap it up with a BowTie on it :-)
1)
Hi, I participated in this thread back in 06 and I believe Pontiac1976 both found what we were looking for. I experienced some medical issues since then and am just getting around to putting the dash in my 76 Chev C20 PU back together. Original cluster had no TACH and the new stock cluster of same year, has a TACH and so, other gauges are rearranged. Shouldn't be a problem since it appears the printed circuit accounts for that. Current status:
1) I have no plug and harness in dash for the TACH and I don't know which of the 3 prongs on back of TACH go to coil, which to switchable hot, and which to ground.
2) Mechanical Oil pressure works fine.
3) Speedometer is fine.
4) Turn signal blinkers and backlights are fine.
5) Amp, Temp and Fuel don't peg, wiggle or register when ignition is turned on.
Can anyone help me trouble shoot the issues> As always, thanks in advance for all help. I hope to make a run at this project this next couple of months and wrap it up with a BowTie on it :-)
1)
