|
Post by my75chevy on Jul 12, 2010 3:18:00 GMT -5
hello everyone ok here goes i just acquired a 1975 chevy 2wd 1/2 ton long bed non running the cost was free and had a clear title my question is i would like to cut the frame and make swb. my neighbor is a master fabricator with over 30 years experience, and his dad has more experience in fabricating.. my neighbor has built several cars from the ground up... so my question is would any1 else take on this job if it was your truck and cut the frame it just slam it as a long bed thanks for your help and any info u can give
|
|
|
Post by Pontiac1976 on Jul 17, 2010 15:01:03 GMT -5
Well it can be done anything can be done if there a enough money time & money. That being said If you do not have shorty to check out it will make thing a little bit harder may cost more, redoing things twice. then you have to find a box to fit might be better to get a shorty in the first place. If you have a parts truck shorty and a good long bed truck that would be a big step in doing what you asked. But it is up to you. there a lot of small stuff that you will find that you need .
|
|